Dc To Dc Power Supply Installation; Connecting Electrical Cables To Power Sources; Specifications For Electrical Supply - Honeywell MX3Plus Cradle Reference Manual

DC to DC Power Supply Installation

For use with Honeywell power supplies:
9000301PWRSPLY – Power Supply, 18-60VDC with cable
l
9000302PWRSPLY – Power Supply, 60-110VDC with cable
l

Connecting Electrical Cables to Power Sources

The DC to DC power supply is used to provide vehicle power to the MX3Plus when placed in a DC powered vehicle dock.

Specifications for Electrical Supply

Input Voltage Always observe input voltage range specified on the DC to DC power supply.
Output Voltage 12 VDC ± 10%
Power 50 W
Fuse 5 A (slow blow fuse). Fuses are USER SUPPLIED
Note: Refer to the Wiring Schematic
Caution: For proper and safe installation, the input power cable must be connected to a fused circuit on the vehicle. This
fused circuit requires a five Amp maximum time delay (slow blow) high interrupting rating fuse. If the supply
connection is made directly to the battery, the fuse should be installed in the positive lead within 5 inches of the
battery positive (+) terminal. Note: For North America, a UL Listed fuse is to be used.
Caution:
For installation by trained service personnel only.
for wiring colors and connections.
3-15