Connecting Vehicle Power; Dc To Dc Power Supply Installation; Connecting Electrical Cables To Power Sources - Honeywell MX9 User Manual

Connecting Vehicle Power

Complete vehicle cradle mounting and power instruction is contained in the MX9 Cradle Guide.
The MX9 must have a main battery installed before docking the MX9 in a cradle.

DC to DC Power Supply Installation

For use with Honeywell power supplies:
9000301PWRSPLY – Power Supply, 18-60VDC with cable
l
9000302PWRSPLY – Power Supply, 60-110VDC with cable
l

Connecting Electrical Cables to Power Sources

The DC to DC power supply is used to provide vehicle power to the MX9 when placed in a DC powered vehicle dock.
Specifications for Electrical Supply
Input Voltage Always observe input voltage range specified on the DC to DC power supply
Output Voltage 12 VDC ± 10%
Power 60 W
Fuse 5 A (slow blow fuse). Fuses are USER SUPPLIED
Note: Refer to the Wiring Schematic
Caution: For proper and safe installation, the input power cable must be connected to a fused circuit on the vehicle. This
fused circuit requires a five Amp maximum time delay (slow blow) high interrupting rating fuse. If the supply con-
nection is made directly to the battery, the fuse should be installed in the positive lead within 5 inches of the battery
positive (+) terminal. Note: For North America, a UL Listed fuse is to be used.
Caution:
For installation by trained service personnel only.
Warning:
Risk of ignition or explosion. Explosive gas mixture may be vented from battery. Work only in well ventilated area.
Avoid creating arcs and sparks at battery terminals.
for wiring colors and connections.
3-5