Table of Contents
Advertisement
Digital Projection
M-Vision LED+IR series
Info Menu
Information
•
The menu shows information about the projector and the currently selected input source.
•
The System ID can be set to any number between 0 and 255.
LED Hour Reset
•
Press
ENTER/SELECT
to reset the LED hour counter to zero.
Factory Reset
•
Press
to restore all settings to their factory defaults.
ENTER/SELECT
•
When the warning message appears, use
Rev D July 2014
A TOUR OF THE MENUS
or
to select
YES
or
NO
, then press
ENTER/SELECT
to confirm your selection.
Operating Guide
Notes
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
To set the System ID:
- connect one projector at a time and
set each to a different number using
the
command.
op sysid
For more information about this, see
the Connections Guide and the
Remote Communications Guide.
Do NOT do this unless you are
sure that you want to set the LED
hour counter to zero, eg if a new
LED module has been installed.
Do NOT do this unless you are
sure that you want to restore
ALL the current settings to their
factory defaults.
Page Op_17
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the M-Vision LED+IR series and is the answer not in the manual?
Questions and answers