Brightness, Contrast, Color Saturation, Color Tint; Sharpness - Digital Projection M-Vision LED+IR series Installation And Quick Start Manual

Digital Projection
M-Vision LED+IR series
continued
Image Menu

Brightness, Contrast, Color Saturation, Color Tint

•
Adjust the sliders for these settings.

Sharpness

•
Press ENTER/SELECT to open the Shapness sub-menu.
•
In , adjust the single
Simple mode
•
If the simple mode adjustment is not effective then select
•
The Horizontal , Vertical and
•
The Sharpness Overshoot
•
The , and
Horizontal Vertical
areas.
•
The Noise Threshold control can be used to adjust the noise threshold frequency. Frequencies above the threshold are considered
to be 'noise', and will not be sharpened.
Rev D July 2014
slider at the top of the menu, as required.
Sharpness
Advanced mode
Diagonal Sharpness controls can be used to enhance image detail along edges.
control can be used to minimize or eliminate rings or shadows on dominant edges.
, and
Diagonal Texture Texture Overshoot
A TOUR OF THE MENUS
, and adjust the advanced sliders as required:
controls can be used to remove artifacts from textured
Operating Guide
Notes
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
Image Menu
Sharpness submenu
The will not be
Advanced sliders
available unless Advanced Mode
chosen.
Page Op_10
is