Table of Contents
Advertisement
Digital Projection
M-Vision LED+IR series
continued
General Menu
Blank Screen
•
Set this to determine what appears on screen when the projector is searching for a valid input source.
Logo Display
•
Set this to determine whether the Digital Projection logo appears when the projector is switching from Stanby to On.
Auto-Source
•
When this is set to
, the projector will search for an alternative input source when the current input source is disconnected
On
•
When this is set to
, the projector will show a 'blank' screen when the current input source is disconnected.
Off
Test Patterns
•
Select from a range of test patterns.
•
Press
to return to the menu, or
MENU
Blue Only
•
Set this to
On
to display only the blue component of the input signal, for calibration or test purposes.
Rev D July 2014
to return to the currently selected input signal.
ENTER/SELECT
A TOUR OF THE MENUS
Operating Guide
Notes
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
To set what a 'blank' screen looks
like, use the
Blank Screen
setting
in the
.
System menu
Page Op_7
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the M-Vision LED+IR series and is the answer not in the manual?
Questions and answers