Operation Mode - Mitsubishi Electric FR-V520-1.5K to 55K Instruction Manual

3.3.4 Parameter setting method (Example: Method to enable extended function
parameters)
• A parameter value may either be set by updating its parameter number or setting the value digit-by-digit using
.
• To write the setting, change it and press
Example: To change the Pr. 160 "extended function selection" setting from "0" (extended function parameter
invalid) to "1" (extended function parameter valid)
Press to choose the "parameter setting mode".
MODE
Parameter setting mode
FR-DU04
CONTROL PANEL
-1
Hz/r
A
V
MON EXT PU
REV FWD
MODE
To 3.3.5 Operation mode
Current setting
SET
3.3.5

Operation mode

External operation
FR-DU04
MON
MODE
o 3.3.6 Help mode
REMARKS
If one operation mode cannot be switched to another, check the following items.
• External input signals ..... Make sure that the STF and STR signals are off.
• Parameter setting ........... Check the Pr. 79 setting.
for 1.5 seconds.
SET
Most significant
digit flickers
SET
×1 time
or
×9 times
SET
0 to 9
Setting change
Press for
1.5 s
SET
Setting write
If
1) When [FWD] or [REV] indication is lit,
Flicker
2) You cannot set any value outside the parameter setting range.
"1" (extended function parameter valid) has been set in Pr. 160.
If the value and parameter number
writing the value.
Press
PU operation
FR-DU04
-1 CONTROL PANEL
Hz/r
A
V
EXT PU MON
REV FWD
When the Pr. 79 "operation mode selection" setting is "0" (factory setting), the inverter is placed
in the external operation mode at input power-on. At this time, press
twice and press (press
PU
operation mode. For the other values (1 to 8), the operation mode is limited accordingly.
Names and functions of the opera-
(Refer to page 53 for details of Pr. 160.)
Middle digit Least significant
flickers digit flickers
×6 times
or
×4 times
SET
0 to 9
appears
stop operation by pressing STOP
RESET
turning off the forward rotation (STF) or
reverse rotation (STR) signal connected
to the control terminal.
Write a value within the setting range.
appears instead, you did not press
once, press , and restart the setting from the beginning.
SET
PU jog operation
FR-DU04
-1 CONTROL PANEL
Hz/r
A
V
EXT PU MON
REV FWD
MODE
when the parameter unit (FR-PU04V) is used) to switch to the PU
28
tion panel
MON EXT PU
or
REV FWD
do not flicker and
for 1.5 seconds when
SET
-1 CONTROL PANEL
Hz/r
A
V
EXT PU
REV FWD
MODE
on the operation panel
MODE
3