Run And Operation; Checks Prior To Test Run; Basic Operation (Speed Setting, Run, Speed Meter Adjustment) - Mitsubishi Electric FR-V520-1.5K to 55K Instruction Manual

3 RUN AND OPERATION

3.1 Checks prior to test run

Installation check
Check that the inverter is installed correctly in a correct place. (Refer to page 6.)
Wiring check
Check that wiring is correct. (Refer to page 7.)

3.2 Basic operation (Speed setting, run, speed meter adjustment)

3.2.1 Setting the speed and running the motor
(1) Choosing PU operation mode (operation from the operation panel (FR-DU04
ning at 150r/min
1.
Power on Operation mode check
The external operation mode (EXT) is selected when
switching power on with factory setting.
Make sure that the operation command indication "PU" is lit.
If it does not appear, press
mode, and press
When the desired result is not obtained, set the PU operation
mode in Pr.79.
2.
Running speed setting
Set the running speed to 150r/min.
First, press to choose the speed setting mode.
MODE
Then, press to change the setting, and press
to write the value.)
SET
3. Start
Press or .
REV
FWD
The motor starts. The mode is automatically switched
to the monitoring mode and the output speed is displayed.
Stop
4.
STOP
Press .
RESET
The motor is decelerated to a stop.
REMARKS
• The operation speed can be changed by changing the preset speed during operation following the steps 2 and 3 above.
• For monitor display changes by
• To select the PU operation mode in Pr.79 "operation mode selection", set "1" in the parameter. Refer to page 52 for details.
Operation
to choose the operation
MODE
to choose the PU operation mode.
, refer to page 27.
MODE
22
Checks prior to test run
FR-DU04
ON
MON
FR-DU04
(or)
MON
FR-DU04
(or)
FWD REV
MON
FR-DU04
MON
)) and run-
-1
Display
CONTROL PANEL
-1
Hz/r
A
V
EXT PU
REV FWD
CONTROL PANEL
-1
Hz/r
A
V
EXT PU
REV FWD
CONTROL PANEL
-1
Hz/r
A
3
V
EXT PU
REV FWD
-1 CONTROL PANEL
Hz/r
A
V
EXT PU
REV FWD