Checking The Drive Shaft - Yamaha BT1100 2002 Service Manual

SHAFT DRIVE
d. Remove the ring gear bearing housing.
e. Measure the
1.
Plastigauge ®
Ring-gear-to-thrust-washer
clearance
0.1 0.2 mm
f. If the ring-gear-to-thrust-washer clearance is
within specification, install the ring gear bear-
ing housing (along with the ring gear).
g. If the ring-gear-to-thrust-washer clearance is
out of specification, select the correct thrust
washer as follows.
h. Select the suitable thrust washer from the fol-
lowing chart.
Thickness (mm)
i. Repeat the measurement steps until the ring-
gear-to-thrust-washer clearance is within the
specified limits.
Ring-gear-to-thrust-washer
clearance
0.1 0.2 mm
EAS00727

CHECKING THE DRIVE SHAFT

1. Check:
• drive shaft splines
Damage/wear
6-84
CHAS
width of the flattened
Thrust washer
1.2, 1.4, 1.6, 1.8, 2.0
Replace the drive shaft.