Yamaha BT1100 2002 Service Manual page 222

FRONT AND REAR BRAKES
3. Remove:
• brake pads 1
(along with the brake pad shims)
4. Measure:
• brake pad wear limit a
Out of specification
pads as a set.
Brake pad wear limit
0.5 mm
5. Install:
• brake pad shims
(onto the brake pads)
• brake pads
• brake pad spring
NOTE:
Always install new brake pads, brake pad shims,
and a brake pad spring as a set.
a. Connect a clear plastic hose 1 tightly to the
bleed screw 2. Put the other end of the hose
into an open container.
b. Loosen the bleed screw and push the brake
caliper pistons into the brake caliper with your
finger.
c. Tighten the bleed screw.
6 Nm (0.6 m•kg)
d. Install new brake pad shims onto the new
brake pads.
e. Install new brake pads and a new brake pad
spring.
6. Install:
• brake pad spring
• pad pin 1
• pad pin clips 2
• brake caliper
NOTE:
The arrow a on the brake pad spring must point
in the direction of disc rotation.
6-17
CHAS
Replace the brake
42 Nm (4.2 m•kg)