Yamaha BT1100 2002 Service Manual page 142

TIMING GEARS
Front cylinder
1. Install:
(front cylinder)
• springs 1
• dowel pins
• timing drive gear 2
NOTE:
• Insert the suitable pin 3 into the hole of timing
chain drive gear sprocket and match the gear
teeth.
• Push the projections a on the timing drive gear
into the spaces b.
• Align the punch mark c on the timing drive
gear, the punch mark d on the timing chain
drive gear sprocket and the key posision e as
shown.
2. Install:
• claw washer
• lock washer 1
• primary drive gear nut 2
NOTE:
While holding the generator retor with the sheave
holder, tighten the primary drive gear nut.
3. Bend the lock washer tab along a flat side of
the nut.
Rear cylinder
NOTE:
When installing the rear cylinder timing gear,
repeat the front cylinder timing gear installation
procedure. However, note the following points.
1. Install:
• springs
• dowel pins
• timing drive gear
• rotor assembly
Refer to "GENERATOR AND STARTER
CLUTCH".
4-37
ENG
New
110 Nm (11.0 m•kg)