Removing The Generator - Yamaha BT1100 2002 Service Manual

GENERATOR AND STARTER CLUTCH
EAS00347

REMOVING THE GENERATOR

1. Remove:
2. Align:
a. Temporarily install the AC magneto cover
b. Turn the crankshaft clockwise.
c. Align the "T" mark a with the stationary point-
d. Check that the rear piston is at TDC in the
e. The rear piston is at TDC on the compression
f.
3. Remove:
NOTE:
• While holding the generator rotor 2 with the
sheave holder 3, loosen the generator rotor nut.
• Do not allow the sheave holder to touch the pro-
jection on the generator rotor.
4. Remove:
4-49
• camshaft sprocket cover
• tappet covers
Refer to "REAR CYLINDER HEAD".
• "T" mark a (with the stationary pointer b)
without the pickup coil and stator coil.
er b on the crankcase cover (left) when the
rear piston is at TDC on the compression
stroke.
compression stroke.
stroke when there is clearance at both of the
rocker arms. If there is no clearance then turn
the crankshaft clockwise one full turn.
When the "T" mark a is aligned with the station-
ary pointer the punch mark c on the camshaft
sprocket should be aligned with the stationary
pointer d on the cylinder head.
• generator rotor nut 1
• washer
Sheave holder
90890-01701
• generator rotor 1
(with the flywheel puller set 2 and adapter
3)
• woodruff key
ENG