Function Test When Activating Alarm Mode And Png Mode - Unify OpenStage M3 Plus User Manual

Personal alarm functionality
Function Test
Shake Sensor
Please shake
handset
Test Passed!
Function Test
Position Sensor
Please hold handset
in vertical position
Test Passed!
Function Test
Emergency Key
Please press
emergency key
Test Passed!
Function Test
Pull Cord Alarm
Please detach and
attach cord to handset
Test Passed!
Function test when activating Alarm Mode
and PNG Mode
A function test has to be performed before the Alarm Mode or PNG Mode is
used. This test is performed automatically by the handset.
Please follow the instructions on the display.
1. Test: Charge status of battery pack
If the battery pack is adequately charged, no reference is made to the battery
test.
If the battery charge is too low, the message "Battery low!" appears, the entire
function test is cancelled and "Test Failed!" is displayed. Make sure the battery
pack is adequately charged and start the startup procedure again!
2. Test: Alarm sensors (movement test)
Move the handset vigorously for a few seconds. An acknowledgement tone sig-
nals that the test has ended.
Shown on display if the test was successful. If not, the entire function test is can-
celled and "Test Failed!" is displayed. Start the startup procedure again.
3. Test: Alarm sensors (non movement and man down test)
Hold the handset still for a few seconds or put it down. An acknowledgement
tone signals that the test has ended.
Shown on display if the test was successful. If not, the entire function test is can-
celled and "Test Failed!" is displayed. Start the startup procedure again.
4. Test: Alarm key
Press the red alarm key. An acknowledgement tone signals that the test has
ended.
Shown on display if the test was successful. If not, the entire function test is can-
celled and "Test Failed!" is displayed. Start the startup procedure again.
5. Test: Pull Cord Alarm
This test is only performed if the Pull Cord Alarm is activated on the handset.
Remove the cord and re-insert it. An acknowledgement tone sounds both when
the cord is removed and when it is replaced.
Shown on display if the test was successful. If not, the entire function test is can-
celled and "Test Failed!" is displayed. Start the startup procedure again.
Note:
If the function test fails repeatedly, shut down the handset immediately and
send it to the manufacturer.
When the function test has ended, the handset automatically calls the alarm ser-
ver and passes on the test result.
Look out for display and voice output from the alarm server.
79