Sending An Emergency Alarm Signal/Calling For Assistance - Unify OpenStage M3 Plus User Manual

Personal alarm functionality
Alarm key
Sending an emergency alarm signal/calling for
assistance
In monitoring mode
The handset is in monitoring mode.
Automatic alarming signal
The alarm sensors in the handset recognise operating statuses that trigger an
alarming signal.
Certain alarm types initially generate a prealarm (configurable). If you do not ac-
knowledge this alarm, the handset sends emergency alarm signals to the con-
figured alarm destination.
Manual alerting
Press the red alarm key on the handset. The handset sends emergency alarm
signals to the configured alarm destination.
An existing call is automatically terminated. The handset repeatedly sends
emergency alarm signals (maximum number of retries is configurable).
The necessary assistance measures are initiated by the location that received
the emergency call following the alarming signal.
In alarm status
The handset has sent an emergency alarm signal and is consequently in alarm
status.
In alarm status: Reset the alarm functionality
The handset is in alarm status.
Press the display key. The handset disables the alarm status/alarming signal
PNG Off
and monitoring.
"PNG Off" is displayed again after every alarm call.
"PNG Off" is only displayed after five alarm calls. If "PNG Off" is not pressed, the
handset repeats the alarm calls according to the configuration. The call duration
and ringing interval are each extended by one second.
Remark:
If you do not want the alarm to be disabled on the handset, a configuration
with an alarm server must be used.
Attention:
Pressing the "PNG Off" display key or pressing and holding (longpress)
the On-hook key either cancels an alarm prematurely or ends it after it has
already been triggered.
The monitoring LED on the handset is now extinguished!
77