Pitney Bowes DM50 Series Operator's Manual page 11

• Be certain the area in front of the wall receptacle into which the
machine is plugged is free from obstruction.
• Before clearing a stoppage, be sure machine mechanisms come
to a stop.
• When removing stalled material, avoid using too much force to
protect against minor personal injury and damaging equipment.
• To prevent overheating, do not cover any vent openings.
• Operation of this equipment without periodic maintenance will
inhibit optimum operating performance and could cause the
equipment to malfunction. Contact your machine supplier for
required service schedule.
• Read all instructions before attempting to operate the equipment.
• Use this equipment only for its intended purpose.
• Always follow the specific occupational safety and health
standards for your workplace.
• This device is not intended for use in the direct field of view at
visual display workplaces. To avoid incommodating reflections at
visual display workplaces this device must not be placed in the
direct field of view.
SDC667C
1 • Introduction
1-5