Polycom QDX 6000 User Manual page 10

1
2
1
2
1
2
3
4
1
2
3
© Polycom, Inc.
You may also be able to use presets that were created at the far site to control
the far-site camera.
To view your near-site presets:
Press Preset on the remote control.
Icons for presets 0-9 are shown on the screen. The colored icons indicate
stored camera positions, and the gray icons indicate available presets.
To move the camera to a preset:
If a call is connected, press
near-site or far-site camera.
Press a number on the remote control.
To store a preset:
If you are in a call, press
select either near-site or far-site control.
If you selected a camera that supports electronic pan, tilt, and zoom, you
can adjust the camera's position:
― Press the arrow buttons on the remote control to move the camera
up, down, to the left, or to the right.
― Press Zoom to zoom the camera out or in.
Press Preset on the remote control.
Press and hold a number to store the preset position. To store a
double-digit preset (10-99), press the first digit quickly and hold the
second number down. Any existing preset stored at the number you
enter is replaced.
The preset 0 is used as the default camera position.
To delete all presets:
If you are in a call, press
Press Preset on the remote control.
Press and hold
You cannot delete just one preset. Instead, overwrite an existing preset with the new
camera position.
User's Guide for Polycom QDX 6000 Systems
Near or
Near or
Near, then choose a near-site video source.
Delete to delete all presets.
Far, then choose a
Far on the remote control to
7