Control Buttons - Kaco Powador 2002 Operating Manual

Configuration and Operation
Non-grid feed mode
Fault
Fault
8.1.2 Display
The display shows measured values and data and allows the confi guration of the inverter. In normal operation, the
backlighting is switched off . As soon as you press one of the control buttons, the backlighting is activated. If no
button is pressed for a minute, it switches off again.
In sleep mode, the inverter deactivates the display regardless of the selected setting.
NOTE
Depending on the tolerances of the measuring elements, the measured and displayed values are not
always the actual values. However, the measuring elements ensure maximum solar yield. Due to
these tolerances, the daily yields shown on the display may deviate from the values on the grid
operator's feed-in meter by up to 15%.
After being switched on and after the initial start-up is complete, the inverter displays the unit name.
Figure 29: Display (shows the unit name or menu item)
8.1.3

Control buttons

Operate the inverter with the two control buttons
Key
Figure 30: Control buttons
Key
1 Shift button
2 Set button
Operating Instructions for Powador 2002-6002_EN
Status message
ok
Fault message
!
Fault message
!
Opens menu
Make settings or selection
The display shows the corresponding
message.
The display shows the corresponding
message.
The red "Fault" LED is illuminated.
The inverter is not ready for grid feed, i.e.
no longer on the grid.
The display shows a SYM bus parameter
error.
Page 33