Assembling The Middle Driven Shaft Assembly; Installing The Middle Gear Assembly And Adjusting The Backlash - Yamaha BT1100 2002 Service Manual

MIDDLE GEAR
ASSEMBLING THE MIDDLE DRIVEN SHAFT
ASSEMBLY
NOTE:
The following points are critical when assembling
the middle gears:
• The collapsible collar must be replaced when-
ever the middle driven shaft assembly is
removed from the middle driven shaft bearing
housing.
• When performing this procedure for the first
time, be sure to have at least one extra col-
lapsible collar on hand.
1. Install:
• bearing outer race
(into the middle driven shaft bearing hous-
ing)
WARNING
Do not press the bearing outer race. During
installation, always press the bearing inner
race carefully.
2. Install:
• middle driven shaft nut
NOTE:
Finger tighten the middle driven shaft mut
INSTALLING THE MIDDLE GEAR ASSEMBLY
AND ADJUSTING THE BACKLASH
NOTE:
When installing the middle gear assembly, be
sure to replace the following parts:
- collapsible collar.
1. Install:
• middle driven shaft assembly 1
4-78
ENG
25 Nm (2.5 m•kg)