4
5
3
2
1
a
EASB0014
INSTALLING THE ENGINE
1. Tighten the bolts in the following order:
2
1
CAUTION:
Install the Ø 12mm washer under the head of
bolt 2.
2. Install:
• shift arm 1
NOTE:
• Align the punch mark in the shift shaft with the
slot 2 in the shift arm
• Install the shift rod joint pin in the shift pedal.
Refer to "ADJUSTING THE SHIFT PEDAL" in
Chapter 3.
3. Check:
• shift pedal position
(distance a from the top of the rider footrest
to the top of the shift pedal)
Out of specification
4-5
ENG
ENGINE
Bolt 1:
65 Nm (6.5 m•kg)
Bolt 2:
65 Nm (6.5 m•kg)
Nut 3:
85 Nm (8.5 m•kg)
Special screw 4:
18 Nm (1.8 m•kg)
Bolt 5:
110 Nm (11.0 m•kg)
Shift arm bolt
10 Nm (1.0 m•kg)
Adjust.
Shift pedal position
(below the top of the rider footrest)
45 mm