Installing The Handlebar - Yamaha BT1100 2002 Service Manual

HANDLEBAR
a. Apply a light coat of rubber adhesive onto the
left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
EASB0025

INSTALLING THE HANDLEBAR

1. Stand the motorcycle on a level surface.
WARNING
Securely support the motorcycle so that there
is no danger of it falling over.
2. Install:
• handlebar
• upper handlebar holders
CAUTION:
• First, tighten the bolts on the front side of
the handlebar holder, then on the rear side.
• Turn the handlebar all the way to the left and
right. If there is any contact with the fuel
tank, adjust the handlebar position.
NOTE:
Align the match marks on the handlebar with the
upper surface of the lower handlebar holders.
6-54
CHAS
23 Nm (2.3 m•kg)