Yamaha BT1100 2002 Service Manual page 260

a
1
a
2
7 2
1
a
3. Install:
1
b
Make sure that the pin a on the throttle cable
housing is aligned with the hole b in the han-
dlebar.
4. Install:
NOTE:
Align the slit in the brake lever holder with the
punch mark a in the handlebar.
5. Install:
NOTE:
Install the master cylinder holder 2 with the mark
"UP" facing up.
6. Install:
NOTE:
Align the slit in the clutch lever a holder with the
2
punch mark in the handlebar.
7. Install:
NOTE:
Aligh the matching surface on the handlebar
switches with the punch mark a on the handle-
bar.
8. Install:
9. Connect:
6-55
CHAS
HANDLEBAR
• throttle grip 1
• throttle cable
WARNING
• master cylinder 1
Refer to "FRONT AND REAR BRAKES".
• master cylinder holder 2
10 Nm (1.0 m•kg)
• clutch lever holder 1
• left handlebar switch 2
• clutch cable
• clutch switch coupler