CLUTCH
EAS00295
INSTALLING THE CLUTCH
1. Install:
• clutch housing 1
NOTE:
If the wire circlip 2 has been removed, carefully
install a new one as shown.
2. Tighten:
• lock washer
New
• clutch boss nut 1
NOTE:
While holding the clutch boss with the clutch hold-
ing tool 2, tighten the clutch boss nut.
Clutch holding tool
90890-04086
3. Bend the lock washer tab along a flat side of
the nut.
4. Lubricate:
• long clutch push rod
• short clutch push rod
(with the recommended lubricant)
Recommended lubricant
Recommended lubricant
5. Lubricate:
• friction plates
• clutch plates
(with the recommended lubricant)
Recommended lubricant
Engine oil
6. Install:
• friction plates
• clutch plates
• long clutch push rod
• short clutch push rod
• bearing
• washer
4-45
ENG
70 Nm (7.0 m•kg)