Conference Calls: Meet Me - Tadiran Telecom T207M User Manual

Conference Calls: Meet Me

In a Meet Me conference, the participants decide on a particular time for commencing the conference. At the designated time,
all participants dial the assigned conference number and password, allowing each one to join the conference.
NOTE! If you do not know the conference number or password, contact your system administrator.
Joining a conference:
1. Dial the conference number at the assigned time. The
enter the conference password.
2. Enter the conference password. Allow for a few seconds until you are transferred to the conference call.
3. Once you are transferred, one of the following messages is displayed depending on the number of participants:
• Conf with Conference Bridge (1)
• Conf with [Name or Number of other participant]
conference
• Conf with [Name or Number of other participants]
conference
• Conf with Conference Bridge (X)
conference call when there are more than three participants.
NOTE! A warning tone will be heard by all the participants.
Adding an additional (ad-hoc) party to a conference:
1. Press or to add additional ad-hoc parties.
XFER [Trns]
2. Dial the destination number of the party you want to add to the conference.
3. Wait for the party to answer.
4. Press to remain on the line to stay connected to the conference.
[Conf]
NOTE! A warning tone will be heard by all the participants.
Station Telephony Features
Conference Calls: Meet Me
Answer MeetMe
- if you are currently the only one in the conference
- if there are currently two participants in the
- if there are currently three participants in the
- message is displayed, indicating the number of parties currently in the
56
message is displayed and you are prompted to
T200M Series User Guide (Coral Sea Softswitch)