Receiver Description; Receiver Features; Receiver Operation - Cisco Prisma II Installation And Operation Manual

Receiver Description

Prisma II High Density Receivers are plug-in modules for the Prisma II and Prisma II
XD platforms. These modules are part of the Prisma II optical network, an advanced
transmission system designed to optimize network architectures and increase
reliability, scalability, and cost effectiveness.
The receiver module installs into a Prisma II XD Chassis directly, or into a standard
Prisma II Chassis by means of a host module that accepts up to two Prisma II High
Density application modules.
The receiver front panel is designed with two optical connectors for optical input
and two test points for RF output verification. All connectors are easily accessible.
ALARM and Power ON indicators on the front panel allow you to monitor power
and alarm status at a glance.

Receiver Features

The receiver has the following features.
Front panel green light emitting diode (LED) to indicate operating status

Front panel red LED to indicate alarm status

-20 dB test point

Optical input connectors

Optical automatic gain control (AGC)

Independently configurable redundancy mode for each receiver channel

Plug-and-play capability

Compatible with Intelligent Communications Interface Module (ICIM2 or

ICIM2-XD), Local Craft Interface (LCI) software, Transmission Network Control
System (TNCS) and ROSA software, Command Line Interface (CLI) software,
and the ICIM Web Interface
Blind-mate radio frequency (RF) connections


Receiver Operation

Reverse receivers are used in conjunction with reverse transmitters to receive reverse
path signals to the hub or headend.
CAUTION:
Some 1310 nm transmitters with serial numbers beginning with NN are not
compatible with these receivers. Do not install these transmitters in any daisy
chain with one or more of these receivers.
78-4015908-01 Rev F

Receiver Description

3