Configuration Summary - Cisco Prisma II Installation And Operation Manual
Prisma ii high density dual reverse receiver
Hide thumbs
Also See for Prisma II:
- Installation manual (180 pages) ,
- Installation and operation manual (124 pages) ,
- Technical bulletin (18 pages)
Table of Contents
Advertisement
Configuration Summary
You can use any of the methods listed above to perform the following configuration
tasks:
Enable or disable each receiver channel
Force Mute
Force Alarm (to service redundant modules)
Select Master, Slave, Single, or Independent operation
Select attenuation level per channel
Configure AGC
Configure redundancy modes
Change receiver wavelength
For detailed information on configuring this module, refer to Operation Using ICIM
(on page 39) or Operation Using LCI (on page 75).
78-4015908-01 Rev F
Module Configuration
11
Advertisement
Table of Contents
Troubleshooting
