Cisco Prisma II Installation And Operation Manual page 89

Note: Refer to your specific hardware Installation and Operation Guide for more
information on using, entering, or changing the ICIM user password.
Press the
3
Result: The ICIM menu appears.
4 Use the
5 Press the
Result: The IP Setup menu appears.
6 Use the
parameter; IP Address, IP Subnet, or Gateway IP.
7 Press the
Result: The Adjust menu for the selected IP parameter displays and the first
segment of the address is highlighted.
Enter the correct numbers for the first segment of the address.
8
Note: One of two methods can be used to enter the numbers, as follows:

Press the

Press the
Numlock On appears on the front panel LCD. Then enter the exact number
using the number keys on the 12-key numeric keypad.
9 Press the
the right. You can also use the
segment of your choice.
Note: If you are using the numeric entry mode, the cursor moves to the next
address segment to the right automatically after you enter the last digit of the
current address segment.
10 Repeat steps 8 and 9 until all address segments are entered.
Result: After you enter the last address segment and press the Enter key, the
system returns to the IP Setup menu.
11 Repeat steps 6 through 10 for each IP Setup parameter that you need to enter.
12 Restart the ICIM.
Important: IP Setup parameters do not take effect until the ICIM is restarted.
78-4015908-01 Rev F
ICIM
key.

key to scroll down until IP Setup is highlighted.
SEL
key.
 
or keys to scroll to and highlight the desired configuration
SEL
key.

or keys to increase/decrease the number to set value.
SHIFT
key to change to the numeric entry mode. Confirm that
ENTER
key to accept your entry and move to the next address segment to
 
or keys to move to the address
SNMP Configuration
65