Receiver Configurable Parameters - Cisco Prisma II Installation And Operation Manual

Appendix A
Module Parameter Descriptions

Receiver Configurable Parameters

Parameter ICIM
Name (LCI) Abbreviation
- NomPwr1
- NomPwr2
Mode Select Mode
Rx 1 Receiver Enable1
Enable
Rx 2 Receiver Enable2
Enable
Rx 1 Mute Switch Mute 1
Rx 2 Mute Switch Mute 2
Rx 1 Attenuator Attn1
Rx 2 Attenuator Attn2
Manual Alarm Alarm
1
Rx 1 Wavelength Wavelen1
Rx 2 Wavelength Wavelen2
AGC 1 Control AGC1
AGC 2 Control AGC2
110
Description
Nominal Rx1 or Rx2 optical input
power level. Input power alarms
are calculated relative to this value.
Module redundancy control. If set
to Master, the unit is only
controlled by the Enable control. If
set to Slave, the unit is controlled by
the Enable control and the external
input CNT_IN.
If set to Single, Rx1 and Rx2 will
continue to operate (i.e. not switch)
even if the optical input level falls
below the major alarm threshold.
If set to Independent, Rx1 and Rx2
are independently set to Master or
Slave mode by Mode1 and Mode2.
Enables or disables Rx1 or Rx2. If
set to Off, the receiver is muted (RF
amplifier turned off), alarms are
inhibited, and redundancy is turned
off.
Defines the initial status of the Rx1
or Rx2 RF Output mute control. If
On, the output is muted. However,
the alarm can override the initial
status and change the mute setting.
Sets the attenuation level of the Rx1
or Rx2 RF Output signal.
Force alarm if the Enable control is
On.
Selects the Rx1 or Rx2 optical
wavelength for proper calibration
of input power measurements.
Enables (Auto) or disables (Manual)
the Rx1 or Rx2 AGC function.
Values Default
Decimal number 0 dBm
between -18.0 and
2 dBm in
increments of
0.5 dBm
Single, Master, Single
Slave, or
Independent
OFF = Disabled ON
ON = Enabled
OFF = Mute Off OFF
ON = Mute On
0 dB to 26.25 dB 0 dB
in increments of
1.0 dB
ON = Alarm On OFF
OFF = Alarm Off
1310 nm or 1310 nm
1550 nm
Manual or Auto Manual
78-4015908-01 Rev F