Adjustment Of The Origin-Point Location; Adjusting The Location Of The Machine's Origin Point - Roland Metaza MPX-80 User Manual

5-4 Adjustment of the Origin-point Location

Adjusting the Location of the Machine's Origin Point

The machine's printing origin point is at the center of the table's scale. When you want to adjust the origin-point
location, output calibration data to verify the location of the origin point.
1.
Print calibration data.
–
Mount material on the center of the table.
Prepare material measuring at least 20 mm (0.8 in.) square.
P. 31, "Loading Material (Using the Adhesive Sheet)", p. 33, "Loading Material (Using the Center Vise)"
—
Start METAZAStudio.
˜
™
Start printing.
2.
Measure and type in the correction values.
–
Material
76 Chapter 5 Maintenance and Adjustment
Center line
Positive direction
for [Length]
Positive direction
for [Width]
Center line
-0.5 mm
0.5 mm
Go to the [File] menu and click
[Open].
For [Look in], select the [Samples]
folder in the [METAZAStudio]
folder*.
* The folder where METAZAStudio is in-
stalled
Select [Axis.dmz].
Click [Open].
Measure and note down the offset between the centerline
on the table scale and the crossed lines on the material.
In the example shown in the figure, the [Width] value is displaced
by 0.5 mm in the positive direction and the [Length] value is offset
by 0.5 mm in the negative direction.