Loading The Material - Roland ColorCAMM PRO PC-600 User Manual

Chapter 2 - Basic Operation

2-3 Loading the Material

Do not allow hands or hair to come
near the platen while the carriage is
in motion.
Failure to do so may result in injury due to
sudden movement of the carriage when the
power is switched on/off, when the sheet
loading lever is raised or lowered,
or when the [CUT TEST] key, [SHEET CUT]
key, [DATA CLEAR] key, or [HEAD
CLEANING] key is pressed.
NOTICE
Please do not try to move the tool
carriage by hand once the power
has been turned on. Doing so may
result in breakdown of the unit.
Actions such as the following must never be attempted, because they may lead to damage of the printing head.
Do not attempt to print on a material that has grit-roller marks.
Do not attempt to print at a location where cutting has been performed (such as an
area used for a cutting test).
Do not use material that is dusty or scratched.
Ink adhesion may suffer if the material's printing surface is not clean. If dirt, oils from the hand, or dusts are
transferred to the material when it is loaded, use a cloth moistened with alcohol to wipe the material clean
before printing.
24
Not OK
Not OK
Roll material must be placed at a
predetermined shaft position.
Failure to do so may
result in falling of the
roll, leading to injury.
Not OK
Grit-roller mark
Cutting-test area