Loading Material Using The Adhesive Sheet - Roland Metaza MPX-90 User Manual

3-2 Getting Ready

Loading Material Using the Adhesive Sheet

Procedure

Switch on the power
 P.30, "Switching On the Power"

Ring
Stopper

Hold the head.
Head cap

Fit the tabs here.
36
Chapter 3 Making Prints
Tighten
Knob
The center of the
knob must be
positioned above
this marking.
Head
Make sure that the stopper con-
tacts the ring and the knob is
tightened as shown in the figure.
Tighten the knob if it is loose. If you make
a print as the knob is loose, the knob may
come off due to vibration.
Attach a head cap to the tip of
head.
Mount it as lightly holding the head as
shown in the figure. The head cap is at-
tached correctly when its tab clicks.
Set the table.
Tab
Fit the tabs on the base of the table to
the holes of the machine.
Tab