Filter Change - Jura IMPRESSA C9 Manual Manual

Filter change

Filter change
Change following a prompt Change following a prompt
k T Press the Rotary Switch to initiate the rinse operation.
RINSING
Rinsing stops automatically and your IMPRESSA is then
ready for use.
Close the cover of the Rotary Switch.
T
After 50 litres of water have flowed through, or after two
E
months, the filter will cease to work. Your IMPRESSA will auto-
matically prompt you to change the filter.
E If the CLARIS plus filter cartridge is not activated, you will not
be prompted to change the filter.
@ You can also try out 'changing the filter' online. Visit the
Knowledge Builder at www.jura.com.
To change the CLARIS plus filter cartridge when prompted to do so
by your IMPRESSA, proceed as follows:
Precondition:
READY
nance button c lights up.
c T Press the maintenance button.
CHANGE
Remove the water tank and empty it.
T
T Open up the cartridge holder and remove the old CLARIS
plus filter cartridge.
T Insert a new CLARIS plus filter cartridge into the water tank,
pressing it slightly.
T Close the cartridge holder. It will click into place audibly.
T Fill the water tank with fresh, cold water and reinsert.
T Place a receptacle (at least 500 ml) under the frother.
E If you are using the Professional Cappuccino Frother, set the
selection lever of the frother to the steam position n.
c T Press the maintenance button.
FILTER RINSING
/ is displayed and the mainte-
FILTER
– Water will flow out of the frother.
 Maintenance