Table of Contents
Advertisement
4040
Flash Test
This test causes the file system to write and read data on the flash to
test the flash device. This test destroys all data on the flash. The
flash is formatted at the end of the test.
1. Enter Diagnostics mode.
2. Select [DEVICE TESTS].
3. Select [Flash Test].
The operator panel displays [Passed] or [Failed].
4. Press Return to return to the Diagnostics mode main menu.
LCD Test
To test the operator panel display:
1. Enter Diagnostics mode.
2. Select [HARDWARE TESTS].
3. Select [LCD Test].
4. Select [Single] or [Continuous].
5. The display goes through a continuous sequence of turning pels
on and off.
6. Press Return to stop continuous LCD test.
7. Press Return to return to the Diagnostics mode main menu.
Memory Tests
1. Enter Diagnostics mode.
2. Select HARDWARE TESTS].
3. Select [Memory Test].
4. Select either [DRAM], or [ROM].
5. Select [Single] or [Continuous].
6. The display indicates [PASSED], or [FAILED].
7. Select [CANCEL] to stop continuous memory test.
8. Press Return to return to the Diagnostics mode main menu.
3-8
Advertisement
Table of Contents
