Table of Contents
Advertisement
4040
Code
Message or Symptom
29
Output Bin Full, top bin only
32
Print Cartridge Missing
37
Insufficient Memory
38
Memory Full
39
Complex Page
51
Defective Flash
52
Flash Full
54
Serial Port Disabled
56
Parallel Port Disabled
57
Check Tray 3
2-8
Action
Remove the paper from the output
face-down bin. Check and
replace if necessary:
• Paper Full Lever (16-4)
• Switch Sensor Board (4-18)
Be sure the print cartridge is prop-
erly installed. Clean or replace the
high voltage power supply con-
tacts (7-2).
No service required, refer to oper-
ator manual.
No service required, refer to oper-
ator manual.
No service required, refer to oper-
ator manual.
Go to Diagnostic Aids and run the
device tests. Replace Flash SIMM
J-7, on the controller card, if nec-
essary.
No service required, refer to oper-
ator manual.
No service required, refer to oper-
ator manual.
No service required, refer to oper-
ator manual.
Be sure the following are correct:
• Tray 3, Paper drawer closed
• Power cord plugged in
• Option controller is installed
• Option controller signal cable is
completely installed.
• If you still have no power to the
paper deck, go to the
Deck Power Input Service
Check" on page
"Paper
2-57.
Advertisement
Table of Contents
