Error Code/Message Tables; Service Error Codes - Lexmark Optra N 4040 Service Manual

4040

Error Code/Message Tables

Service Error Codes

Error Symptom or Message
900 Unrecoverable Software
Error
920 Fuser Error, Fuser lamps do
922 not come on during POR, or
fuser lamps come on but do
not reach operating tempera-
ture after 180 seconds.
923 Fuser Error, Fuser is too hot
or warming up abnormally.
924 Fuser Error, Wrong voltage
927 Fan stalled
931 Printhead Errors
932
933
934
935 Printhead Error
2-4
Action
Refer to the operator manual
Go to the "Fuser (Temperature
Low) Service Check (920/922)" on
page 2-23.
Go to the "Fuser (Abnormal Tem-
perature) Service Check (923)" on
page 2-22.
Go to the "Fuser (Wrong Type)
Service Check (924)" on page
2-24.
Go to the "Fan Motor Service
Check (927)" on page
Check the printhead connectors.
Replace the printhead if neces-
sary. If you still have a failure,
replace the system board (4-9).
If the main motor (MT1) (2-7) runs
during POR, replace the printhead
(4-32). If the motor does not run
during POR, check the connectors
to the motor.
If necessary, replace the motor
and POR the machine. If you still
have a failure, replace the system
board (4-9).
2-19.