Table of Contents
Advertisement
4040
Diagnostics Mode
To run the printer diagnostic tests, you must put the printer in
Diagnostics mode. The controller card must be plugged into the
system board (normal state).
Note: Entering the Diagnostic mode clears NVRAM.
To enter Diagnostics mode:
1. Turn the printer off.
2. Press and hold the Ready and Return buttons as you turn on the
machine. The printer performs the Power-On Self Test.
3. Release the buttons when [Performing Self Test] is displayed.
4. You can exit Diagnostics mode without a POR by selecting
[Reset Printer].
Diagnostics Mode Menu Structure
The following is the Diagnostics mode menu structure, The indented
items are submenus available under the main menu items, which are
in capital letters on the operator panel. Menu items referring to
options will only be present if those options are installed. Menus with
more than four items will use [MORE] on the fourth operator panel
button to access the next screen of selections.
PRINT TESTS
Print Test 1
Print Test 2
Print Test 3
Envelope Print Test
PRINT REGISTRATION
Left Margin
Top Margin
Quick Test
HARDWARE TESTS
LCD Test
3-4
Advertisement
Table of Contents
