Pick-Up Assembly Paper Jams Service Check - Lexmark Optra N 4040 Service Manual

4040

Pick-Up Assembly Paper Jams Service Check

Be sure the recommended paper is being used and that the paper is
not curled or wrinkled.
If Jams occur in the manual feed pick-up assembly, perform step 3
below and all subsequent steps.
If jams occur in the cassette paper pick-up assembly, perform step 6
and all subsequent steps.
FRU
1 Registration
Clutch
2 Registration
Roller
3 Paper
4 Manual
Feeding Pick-
Up Roller
Pick-up
5
Roller
6 Cassette
Action
The registration clutch does not work properly.
Go to the "Registration Roller Service Check"
on page 2-29.
The registration roller could be worn,
deformed, or dirty. Clean or replace as
required (12-10).
There could be too much paper on the multi-
purpose tray. Check and advise the customer
not to over load the tray with paper.
The manual feed lift plate may be binding due
to excessive lubrication. The manual feeding
pick-up roller could be worn, deformed, or
dirty. Clean the manual feeding pick-up roller if
it is dirty. Replace if worn or deformed (14-14).
The pick-up roller may not rotate when a print
is being made. Go to the
Multipurpose Tray Service Check" on page
2-27.
The cassette may not be positioned correctly. Re-
position the cassette properly.
There could be too much paper in the cassette.
Run the paper feed test in Diagnostic Aids to deter-
mine which paper path is causing the problem.
"Paper Pick-Up from
Diagnostic Information 2-51