Product Setup - D-Link DES-1008P+ Quick Installation Manual

PRODUCT
SETUP
BEFORE SETTING UP THE DES-1008P+
Please follow the steps below to set up the switch:
1. Install the DES-1008P+ in a cool and dry place. Refer to the Technical Specifications for the
acceptable operating temperature and humidity ranges.
2. Install the switch in a site free from strong electromagnetic source, vibration, dust, and direct
sunlight.
3. Leave at least 10 cm of space at the left and right-hand side of the switch for ventilation.
4. Visually inspect the power jack and make sure that it is fully secured to the power adapter.
Do not stack any device on top of the switch.
CONNECTING THE DES-1008P+ TO YOUR NETWORK
A. POWER
Plug the AC power cord into a free wall socket, then plug the other end of the power cord into the
power outlet of the DES-1008P+. The Power LED will illuminate confirming that the device has
powered up successfully.
B. PoE PORTS (PORTS 1 - 8)
The POE Ports 1 to 8 support 802.3at for up to 30W per port for individual usage. The total POE
budget is 140 Watts.Supports first plug first power. When total power consumption has reached max
power budget, new PD device will not get power.
C. FAST ETHERNET PORTS (PORTS 1 - 8)
These ports offer network speeds of either 10 Mbps, 100 Mbps Mbps and can operate in half and full-
duplex transfer modes. These ports also support automatic MDI/MDIX crossover, eliminating the need
for crossover cables or uplink ports. Each port can be connected directly to a server, hub, router, or
switch using regular straight-through twisted-pair Ethernet cables.
DES-1008P+
8 PoE Ports & 8 10/100Mbps Ports
3