Answering Calls With The Trunk Keys; Dialing With Trunk Keys; Placing A Call On Hold On A Trunk Key And Retrieving The Held Call - Siemens HiPath 2000 User Manual

Making calls in the team/executive/secretary configuration
Step by Step
144

Answering calls with the trunk keys

Prerequisite: You can see an incoming call on a trunk.
T
if nec.
Press the trunk key that is flashing quickly
(only if Prime Line
^
Lift the handset.
or Speakerphone mode.

Dialing with trunk keys

S
if nec.
Select a line (only if Prime Line
tive).
j
Enter the station number.
^
Lift the handset.
or Speakerphone mode.
Placing a call on hold on a trunk key and
retrieving the held call
Prerequisite: You are conducting a call via one of your
group's trunks. The "Hold" key has been programmed
on your telephone
Hold
S
Press the "Hold" key.
if nec.
\ s
or
Replace the handset or press the key shown.
Depending on the configuration (contact your service
personnel), this may be necessary so other team mem-
bers can also pick up the call on hold.
Retrieving the call
T
Press the trunk key flashing slowly.
page 143 is not active).
page 143 is not ac-
page 91.