Restoring Default Settings - LifeSize Room User Manual

Restoring Default Settings

You may need to reset the system to its default state to correct unknown problems you may
be experiencing or to return to a known configuration.
You can reset the system from the user interface by accessing Diagnostics : System
Reset. If this reset fails or if you do not have access to the user interface, you can manually
reset the system using the Reset button on the back panel of the codec.
If power is connected to the system when you press and hold the Reset button until the LED
on the front begins to blink, release the button and the system restarts. (This is an
alternative method to power cycle the system without unplugging the power cord.)
If the system is unplugged or power is unavailable when you press the Reset button and you
then apply power, the red LED illuminates and one of the following occurs:
• If you press the button for more than 5 seconds but less than 10 seconds, the LED
flashes and the system starts at the initial configuration and resets values to default
settings.
• If you press the button for more than 10 seconds but less than 15 seconds, the LED
flashes and the system starts using the previous installed version of software.
• If you press the button for more than 15 seconds, the LED flashes and the system starts
and stops in diagnostic mode. Contact Customer Support for assistance with
diagnostics.
39 LifeSize Room User Guide