Managing The Display - LifeSize Room User Manual

Managing the Display

LifeSize Room connects to most displays, including:
• Plasma flat panel displays
• CRT monitors (720p displays)
• Large screen rear projection TV displays (720p displays)
• Front projection displays
• Rear projector A/V room configurations
If you connect your system to an unsupported display, an error message appears. Ensure
your monitor or projector meets display resolution requirements. Refer to the LifeSize Room
Release Notes for specific resolutions supported.
Your display shows the far-end and near-end video conferencing sites in addition to the
menus and video from connected video sources. Refer to "User Preferences" on page 21 for
details about customizing display settings.
Selecting Input
To select a new input, follow these steps:
1. Press the Near button on the remote control (or navigate to the PIP window and press
OK to enable full screen for the primary input.)
2. Press the Near button again or press the
selection dialog containing small representations of the available input sources.
The default primary input is the High Definition Camera.
3. Accept the default by pressing OK, or change the default value by selecting the desired
input and pressing OK.
4. Press the button to proceed to the Secondary Input selection dialog containing
small representations of the available input source.
The default secondary input is the VGA input, named PC.
5. Accept the default by pressing OK, or change the default value by selecting the desired
input and pressing OK.
6. Press the button to return to the main screen and place a call.
To define custom input names, see your administrator to change the default values. Refer to
"Configuring Video Behaviors" on page 28 for more information.
16
button to display the Primary Input
LifeSize Room User Guide