Replacing The G-Trac Sensor - Invacare Storm4 Max Service Manual

® 4
Invacare - STORM
7.4.5

Replacing the G-Trac sensor

Requirements:
 5 mm Allen key
 10 mm socket wrench
Uninstalling the G-Trac sensor:
 Remove the seat, as described in chapters 7.6.1 and 7.6.5.

Switch the electronics of the wheelchair OFF.

Remove the rear cover, as described in chapter 7.1.1.

Take note of the positions of all cables and the sockets that they are connected to. Mark the
connectors and sockets or take a photograph with a digital camera.
 In the illustration above, you see the power module (3) and the positions of the optional lighting
circuit board (2), of the optional actuator module (1) and of the optional G-Trac sensor (4).

Remove the rear cover, as described in chapter 7.1.1.
 Press both locking bolts inwards and open the battery box cover.
MAX SERVICE MANUAL
59