Table of Contents
Advertisement
To enable the Center V2 connection:
1. Activate Link: Enable the monitoring through Center V2.
2. Host Name or IP Address: Type the host name or IP address of Center V2.
3. Port Number: Match the port to the GV-Video Server port on Center V2. Or keep the
default value 5551.
4. User Name: Type a valid user name to log into Center V2.
5. Password: Type a valid password to log into Center V2.
6. Click Apply. The Connection Status should display "Connected" and connected time.
These options you can also find on this Center V2 setting page:
Cease motion detection messages from: Stops notifying Center V2 of motion
detection from selected camera(s).
Cease input trigger messages from: Stops notifying Center V2 of input trigger from
selected input(s).
Enable schedule mode: Starts the monitoring through Center V2 based on the
schedule you set in the Select Schedule Time section. Refer to 4.5 Recording
Schedule for the same settings.
For related settings to activate the monitoring through Center V2, see 4.1.2 Motion
Detection, 4.2.2 Input/Output Setting, and 8.1 Center V2.
Administrator Mode
4
39
Advertisement
Table of Contents
