Figure 3-25 Processor Cable Placed Correctly - HP 9000 rp4410 User's & Service Manual

Step 5. Carefully lower the processor, without the sequencer frame, onto the processor socket. Align the
pins on the bottom of the heatsink to the slots in the retention frame on the extender board.
CAUTION
TIP
CAUTION

Figure 3-25 Processor Cable Placed Correctly

Chapter 3
Do not press the processor modules into the socket. When properly assigned, the
processor pins seat into the socket by themselves. You can damage the pins if you
apply pressure.
Test the alignment of the assembly to the socket by gently moving the assembly back
and forth with the palm of your hand—you should feel little or no side play. However,
because the assembly is not yet tightened, it can tilt slightly toward the center of the
extender board; this is acceptable.
Before locking the processor assembly into its socket, ensure that the power cable is
not pinched between the heatsink and sheet metal frame of the extender board. Also,
ensure that the two power cable ends attached to the dual processor module do not
come unplugged from their sockets when you move the cable into place under the
heatsink. See Figure 3-25 and Figure 3-26.
Installing the System
Installing Additional Components
Heatsink
Cable Placed Correctly
Under Heatsink
Protective Plastic Sleeve
Sheet Metal Frame
91