Ola - HP 9000 rp4410 User's & Service Manual

Removing and Replacing Components
Removing and Replacing PCI/PCI-X Cards
Table 6-6 PCI I/O Hardware Paths (Continued)
PCI Card Functionality
PCI Slot 2 - GigaBit LAN Port B
PCI Slot 3
PCI Slot 4
PCI Slot 5
PCI Slot 6
PCI Slot 7
PCI Slot 8
UPS Communications Controller
Local/Remote Serial Controller

OLA

Before installing a PCI/PCI-X card, ensure that the proper drivers for that PCI/PCI-X card are installed.
NOTE If you are installing the Graphics Kit A6150B, use slots 3-8. However, do not install the
included USB card. The server currently supports USB and the ports are already located on the
rear of the server.
If you are installing the RAID card A7143A, you must install it into slot 8. If you install this
card in any other slot, it interferes with the manual retention latch (MRL) on the OLX divider
in the next slot. Because of this interference, you can install only two RAID cards in the system
in slot 1 and slot 8.
To add a PCI/PCI-X card into an empty slot, follow these steps:
Step 1. If rack-mounted, slide the server out from the rack until it stops. (See "Accessing a Rack-Mounted
Server" on page 177.)
Step 2. Remove the top cover from the chassis. (See "Removing the Top Cover" on page 182.)
Step 3. Select an empty slot and pull up on the MRL located on the OLX divider approximately 75 degrees.
220
Mapper HP-UX
Path Path
0/1/2/1 0/1/2/1
0/4/1 0/4/1
0/4/2 0/4/2
0/5/1 0/5/1
0/5/2 0/5/2
0/2/1 0/2/1
0/6/1 0/6/1
0/0/1/0 0/0/1/0
0/0/1/1 0/0/1/1
PCI Bus
Address
0x20-0x3F
0x80-0x9F
0x80-0x9F
0xA0-0xBF
0xA0-0xBF
0x40-0x7F
0xC0-0xFF
0x00-0x1F
0x00-0x1F
Chapter 6