Configuring The Ilo Mp Lan Using Dhcp And Dns; Configuring The Ilo Mp Lan Using Arp Ping - HP 9000 rp4410 User's & Service Manual

Installing the System
Console Setup
Table 3-15 LAN Configuration Methods (Continued)
DHCP DNS
No Yes
No Yes
Yes No
No No
Yes No
Once you have determined how you will configure the iLO MP LAN in order to acquire an IP address, you
must configure the iLO MP LAN using the selected method.

Configuring the iLO MP LAN Using DHCP and DNS

DHCP automatically configures all DHCP-enabled servers with IP addresses, subnet masks, and gateway
addresses. All HP 9000 entry class servers with iLO MP are shipped from the factory with DHCP enabled.
HP recommends using the DHCP and DNS method to simplify access to the iLO MP.
TIP
When you use DHCP and DNS, you can connect to the iLO MP by typing the DNS name in the browser rather
than an IP address only if the following conditions apply:
• DHCP must be enabled (DHCP is enabled by default).
• You are using a DHCP server that provides the domain name and the primary DNS server IP address.
• The primary DNS server accepts dynamic DNS (DDNS) updates.
• The primary DNS server IP address has been configured through the DHCP server.
To configure the iLO MP using DHCP and DNS, follow these steps:
Step 1. Obtain the factory-set DNS name from the toe-tag on the server. The DNS name is 14 characters
long, consisting of the letters
mp0014c29c064f. This address is assigned to the iLO MP hardware. The iLO MP has a unique
MAC address that identifies the hardware on the network.
Step 2. Connect the LAN cable from the server to an active network port.
Step 3. Apply ac power to the server (if not already done).
Step 4. Open a browser, telnet, or SSH client and enter the DNS name. The Integrity
opens.

Configuring the iLO MP LAN Using ARP Ping

The Address Resolution Protocol (ARP) and Packet Internet Grouper (Ping) utility uses ARP packets to ping,
or discover, a device on the local network segment. The IP address you assign to the server must use the same
network segment, or subnet, as the computer assigning the address. ARP does not work across routed or
switched networks.
122
RS-232 Serial Port
(iLO MP LC command)
No
Yes
Yes
Yes
No
followed by the 12 characters of the MAC address, for example:
mp
LAN Configuration Method
ARP Ping
ARP Ping, RS-232 serial port, or remote/modem port
RS-232 serial port, or remote/modem port
RS-232 serial port, remote/modem port, or ARP Ping
Cannot set up the LAN. Reconsider your criteria.
window
iLO MP Log In
Chapter 3