Installing The Lan Core I/O Card; Removing The Scsi Core I/O Card; Figure 6-44 Installing The Lan I/O Card - HP 9000 rp4410 User's & Service Manual

Installing the LAN Core I/O Card

To install the LAN core I/O card, follow these steps:
Step 1. Insert the replacement LAN core I/O card into slot 2.
CAUTION

Figure 6-44 Installing the LAN I/O Card

Step 2. Close the blue PCI card latch for slot 2 by twisting it counterclockwise.
Step 3. Reconnect the LAN cables to the LAN core I/O card. Be sure to attach cables to their original
connectors.
Step 4. Replace the top cover. (See "Replacing the Top Cover" on page 183.)
Step 5. Push the server back into the rack until it stops.

Removing the SCSI Core I/O Card

To remove the SCSI core I/O card in slot 1, follow these steps:
Step 1. If rack-mounted, slide the server out from the rack until it stops. (See "Accessing a Rack-Mounted
Server" on page 177.)
Step 2. Remove the top cover from the chassis. (See "Removing the Top Cover" on page 182.)
Chapter 6
Always handle I/O cards by their edges. Failure to comply with this precaution can
result in damage to the card.
Ensure that you fully seat the card into the slot or the card can be damaged when
power is reapplied to the slot.
Removing and Replacing Components
Removing and Replacing Core I/O Cards
247