Hot-Pluggable Disk Drives; Removing A Hot-Pluggable Disk Drive; Replacing A Hot-Pluggable Disk Drive - HP 9000 rp4410 User's & Service Manual

Removing and Replacing Components

Hot-Pluggable Disk Drives

Hot-Pluggable Disk Drives

The two hot-pluggable disk drives are located in the front of the HP 9000 rp4410 and rp4440 servers. The
hot-pluggable disk drives are replaced using the procedures in this section when power is on or off.
CAUTION A hot-pluggable device can require interaction with the operating system before the device can
be safely removed from or installed into the server. Verify that the operating system supports
removing and replacing disk drives while the operating system is running. If the operating
system does not support this feature, shut down the operating system before attempting this
procedure. Failure to observe this caution results in system failure.
NOTE The replacement disk drive must be the same product ID as the disk drive that is being
replaced.
HP often uses different manufacturers for disks that have the same product number. The
replacement disk drive will have the same capacity and block size as the defective disk if they
have the same product number.

Removing a Hot-Pluggable Disk Drive

NOTE For cooling purposes, always leave the volume filler in slot 2 if you do not use a second disk
drive.
To remove a hot-pluggable disk drive, follow these steps:
Step 1. Grasp the tab of the latch on the selected disk drive.
Step 2. Push the tab toward the latch and pull the latch out; the disk unlocks.
Step 3. Pull gently until the disk drive slides out of the chassis.

Replacing a Hot-Pluggable Disk Drive

One additional hot-pluggable disk drive can be added to the server in slot 2. Always use low profile disk drives
(1 in high) in the HP 9000 rp4410 and p4440 servers.
250
Chapter 6