Figure 6-10 Inserting Dimm Into The Extender Board Connector - HP 9000 rp4410 User's & Service Manual

Supported DIMM Sizes
You can install up to 128 GB of memory in the server. Supported DIMM sizes are as follows:
• 256 MB, 512 MB, 1 GB, 2 GB, 4 GB
Dissimilar DIMM sizes can be used across the extender board, but all four DIMMs in each quad must match.
For cooling purposes, DIMM fillers must be used in some unused connectors.
DIMM Slot Fillers
Both the 16- and 32-DIMM extender boards have DIMM slot filler boards placed over all unfilled DIMM
connectors. As you fill DIMM quads with additional memory you must remove the DIMM slot fillers covering
the affected connectors. All remaining DIMM fillers in unused connectors must remain in place to maximize
internal cooling (Table 6-1).
NOTE One DIMM filler board covers two adjacent DIMM connectors. Remove DIMM slot fillers as you
add memory and the correct configuration will always remain.
Installing DIMMs
To install DIMMs, follow these steps:
Step 1. Align the DIMM with the socket located on the memory extender board; and align key in connector
with the notch in the DIMM.

Figure 6-10 Inserting DIMM into the Extender Board Connector

Chapter 6
Removing and Replacing Components
System Memory DIMMs
191