Table 3-12. Hot-Pluggable Led Descriptions - HP 9000 rp4410 User's & Service Manual

Installing the System
Installing Additional Components
IMPORTANT When inserting the PCI/PCI-X card, be careful you do not accidentally touch an
NOTE
Step 11. If the PCI/PCI-X card is full size, close the slider gate latch to secure the end of the card.
(Figure 3-33)
Step 12. Push the MRL down until it seats against the chassis wall.
Step 13. Turn the PCI/PCI-X card latch on the chassis to the closed position. This locks the PCI/PCI-X card
into its slot and the MRL into the closed position.
Step 14. Press the
Attention
Step 15. Wait for the power LED to stop blinking. The PCI/PCI-X card is now active.
Step 16. Reconnect all cables.
Step 17. Replace the top cover. (See "Replacing the Top Cover" on page 74.)
Step 18. Push the server all the way back into the rack until it stops.
Understanding LEDs and Hardware Errors
Table 3-12 describes the hot-pluggable LED error conditions.
Table 3-12 Hot-Pluggable LED Descriptions
Power LED (Green)
Attention LED (Amber)
108
button on the other OLX dividers. This initiates an undesired shutdown of
Attention
another PCI/PCI-X card/slot. If you accidentally initiate slot shutdown, push the
button again within five seconds to cancel the shutdown.
Attention
Ensure that you fully seat the card into the slot, or undesired results can occur after
power is reapplied to the slot.
button. The power LED starts to blink.
Condition
On
Blinking
Off
Condition
On
Blinking
Off
PCI/PCI-X slot is powered on
Hot-pluggable operation in progress. Do not touch the slot
PCI/PCI-X slot is powered off
Description
Hardware operational fault
NOTE: If the slot is powered on, it does not power off. If the
slot is powered off, it does not power on
Slot location is being indicated
If power to the slot is on, the slot is functioning normally
Description
Chapter 3