Replacing The Memory Extender Board; Figure 6-7 Memory Extender Board - HP 9000 rp4410 User's & Service Manual

Removing and Replacing Components
Memory Extender Board
Step 5. Pull on the extraction levers to unplug the memory extender board from the socket located on the
midplane riser board and remove the memory extender board from the chassis.

Figure 6-7 Memory Extender Board

Replacing the Memory Extender Board

To replace the memory extender board, follow these steps:
Step 1. Ensure that the extraction levers are in the outward, unlocked position.
Step 2. Align the memory extender board with the front and rear chassis guide slots.
Step 3. Slide the memory extender board in until it begins to seat in the socket located on the midplane
board.
Step 4. Push the extraction levers inward to the locked position to fully plug the memory extender board
into the midplane riser board.
Step 5. Replace the front cover. (See "Replacing the Front Cover" on page 182.)
Step 6. Replace the front bezel. (See "Replacing the Front Bezel" on page 180.)
186
Chapter 6