Figure 1-31 Inserting Dimm Into The Extender Board Connector - HP rp4410 Installation Manual

Installing the System
Installing Additional Components
Installing DIMMs
To install DIMMs, follow these steps:
Step 1. Align the DIMM with the socket located on the memory extender board. (Align the notch in the
DIMM with the tab in the connector.)
Step 2. Firmly and evenly push on each end of the DIMM until it seats in the socket. Ensure that the
extraction levers are in the closed position.

Figure 1-31 Inserting DIMM Into the Extender Board Connector

Replacing the Memory Extender Board
To replace the memory extender board, follow these steps:
Step 1. Ensure that the extraction levers are in the outward, unlocked position.
Step 2. Align the memory extender board with the left and right chassis guide slots.
Step 3. Slide the memory extender board in until it begins to seat in the socket located on the midplane
riser board.
Step 4. Push the extraction levers inward to the locked position to fully plug the memory extender board
into the midplane riser board.
Step 5. Replace the front cover onto the chassis. (See "Replacing the Front Cover" on page 30.)
56
Chapter 1